User Manual
Table Of Contents
- USER’S GUIDE MFC-5440C/MFC-5840CN
- APPROVAL INFORMATION
- Compilation and Publication Notice
- Safety precautions
- Choosing a location
- Quick Reference Guide
- Table of Contents
- 1 Introduction
- 2 Getting started
- 3 Setup Send
- How to enter Fax mode
- How to dial
- How to Fax (B&W and Colour)
- Basic sending operations
- Advanced sending operations
- Broadcasting (Not available for colour faxes)
- Overseas Mode
- Delayed Fax (Not available for colour faxes)
- Delayed Batch Transmission (Not available for colour faxes)
- Setup for Polled Transmit (Standard) (Not available for colour faxes)
- Setup for Polled Transmit with Secure Code (Not available for colour faxes)
- TX Lock (Key Lock for some countries)
- Faxing letter size documents from the scanner glass
- 4 Setup Receive
- 5 Quick-Dial numbers and dialling options
- 6 Remote Fax Options (Not available for colour faxes)
- 7 Printing reports
- 8 Making copies
- 9 Walk-Up PhotoCapture Center™ (MFC-5840CN only)
- 10 Important information
- 11 Troubleshooting and routine maintenance
- Appendix A
- Telephone Service for Australia
- Telephone Service for New Zealand
- Telephone Service for Some Countries
- Advanced receiving operations
- Connecting an external device to your MFC
- Appendix B
- Glossary
- Specifications
- Index
- Remote Retrieval Access card
- brother ARL/ASA/NZ
GETTING STARTED 2 - 4
General Setup
Setting the Mode Timer
The MFC has three temporary mode keys on the control panel: Fax,
Scan and Copy. The PhotoCapture key (MFC-5840CN only) is also
a temporary mode key. You can change the number of seconds or
minutes that the MFC takes after the last Scan, Copy or
PhotoCapture operation before it returns to Fax mode. If you select
Off
, the MFC stays in the mode you used last.
1
Press
Menu/Set
,
1
,
1
.
2
Press
▲
or
▼
to select
0
Sec
,
30
Secs
,
1
Min
,
2
Mins
,
5
Mins
or
Off
.
Press
Menu/Set
.
3
Press
Stop/Exit
.
Setting the Paper Type
To get the best print quality, set the MFC for the type of paper you
are using.
1
Press
Menu/Set
,
1
,
2
.
2
Press
▲
or
▼
to select
Plain
,
Inkjet
,
Glossy
or
Transparency
.
Press
Menu/Set
.
3
Press
Stop/Exit
.
■
The MFC ejects paper with printed surfaces face up onto the
paper tray in the front of the machine. When you use
transparencies or glossy paper, remove each sheet
immediately to prevent smudging or paper jams.
■
(MFC-5840CN only)
You can only use plain paper in Tray#2.
(MFC-5840CN only)
General Setup
1.Mode Timer
General Setup
2.Paper Type