User Manual
Table Of Contents
- USER’S GUIDE MFC-5440C/MFC-5840CN
- APPROVAL INFORMATION
- Compilation and Publication Notice
- Safety precautions
- Choosing a location
- Quick Reference Guide
- Table of Contents
- 1 Introduction
- 2 Getting started
- 3 Setup Send
- How to enter Fax mode
- How to dial
- How to Fax (B&W and Colour)
- Basic sending operations
- Advanced sending operations
- Broadcasting (Not available for colour faxes)
- Overseas Mode
- Delayed Fax (Not available for colour faxes)
- Delayed Batch Transmission (Not available for colour faxes)
- Setup for Polled Transmit (Standard) (Not available for colour faxes)
- Setup for Polled Transmit with Secure Code (Not available for colour faxes)
- TX Lock (Key Lock for some countries)
- Faxing letter size documents from the scanner glass
- 4 Setup Receive
- 5 Quick-Dial numbers and dialling options
- 6 Remote Fax Options (Not available for colour faxes)
- 7 Printing reports
- 8 Making copies
- 9 Walk-Up PhotoCapture Center™ (MFC-5840CN only)
- 10 Important information
- 11 Troubleshooting and routine maintenance
- Appendix A
- Telephone Service for Australia
- Telephone Service for New Zealand
- Telephone Service for Some Countries
- Advanced receiving operations
- Connecting an external device to your MFC
- Appendix B
- Glossary
- Specifications
- Index
- Remote Retrieval Access card
- brother ARL/ASA/NZ
INTRODUCTION 1 - 5
Turning the MFC to Power Save condition
When the MFC is idle, you can turn it to Power Save condition by
pressing the Power Save key. In Power Save mode, the MFC will
receive telephone calls as normal. For further information on
receiving faxes in the power save condition, please see the table on
page 1-6. The delayed faxes that have been set up will be sent. You
can even retrieve faxes using Remote Retrieval if you are away from
your MFC. If you want to do other operations, you must turn the MFC
back on.
Turning the MFC to Power Save condition
Press and hold down the
Power Save
key until the LCD shows:
The LCD light will go off.
Turning the MFC to Power Save condition off
Press and hold down the
Power Save
key until the LCD shows:
The LCD will show the date and time (Fax
mode).
Even if you have turned the MFC off, it will periodically clean the
print head to preserve print quality.
If you unplug the AC power cord, no MFC operations will be
available.
You can turn the MFC Off by customizing the
Power Save
key
as shown next page. In this Off mode, no MFC operation will be
available. (See
Power Save Setting
on page 1-6.)
The external telephone or TAD is always available.
Shutting Down
Please Wait