User Manual

Making copies
79
11
Using a scanned paper document as
your watermark
11
a Press (Copy).
b Enter the number of copies you want.
c Press a or b to choose
Watermark Copy.
Press OK.
d Press d or c to choose On.
e Press a or b to choose
Current Setting.
Press OK.
f Press a or b to choose Scan. Press OK,
and place the page that you want to use
as a watermark on the scanner glass.
g Press Mono Start or Colour Start.
h Take out the watermark document you
scanned and load the document you
want to copy.
i Press d or c to change the
Transparency of the watermark.
Press OK.
j If you do not want to change any
additional settings, press Mono Start or
Colour Start.
Note
You cannot enlarge or reduce the
scanned watermark.
Setting your changes as a
new default 11
You can save the copy settings for Quality,
Enlarge/Reduce, Brightness,
Contrast or Page Layout that you use
most often by setting them as the default
settings. These settings will stay until you
change them again.
a Press (Copy).
b Press a or b to choose your new setting.
Press OK.
Repeat this step for each setting you
want to change.
c After changing the last setting, press
a or b to choose Set New Default.
Press OK.
d Press 1 to choose Yes.
e Press Stop/Exit.
Restoring all settings to the
factory settings 11
You can restore all the settings you have
changed back to the factory settings. These
settings will stay until you change them again.
a Press (Copy).
b Press a or b to choose
Factory Reset.
Press OK.
c Press 1 to choose Yes.
d Press Stop/Exit.