Owner's Manual

Programmer
144
Chapter 3 Programming with Command Function
Changing partially
A part of the programmed pattern is changed. The
example in the left is used for explanation of creating
5', 6' and 7'.
1
Calling data
1. Specify the program number on the
operation panel and press the read/write
switch to read the data.
2
Moving to position 4.
1. Press
9
9 9
and press .
The work clamp moves from the start position by each stitch.
2. When the needle point reaches 4, press .
The work clamp stops. If the work clamp passes, input a few
stitches and press . The needle returns for a few stitches of
the input.
3
Programming a new point.
1. Move the work clamp with . Press
L
when the needle point is at 5'.
5' is programmed.
2. Repeat step 1 and program 6' and 7'.
3. Press
1
and press .
The needle point moves to 5.