Service manual

REPAIR
Mechanical
SERVICE MANUAL
4-46
5.3.4.1. Removing the Carriage
The outline of the printer mechanism is shown in Fig. 4.37.
The procedure for removing the carriage is explained below.
(1) If necessary, remove the ink cartridge and store it in a safe place.
(2) Loosen the idle pulley holder screw and remove the idle pulley holder spring to
remove the timing belt from the idle pulley.
(3) Remove the screw from the main shaft stopper and remove the main shaft stopper.
(4) Remove the main shaft by sliding it to the right.
(5) Remove the FPC locker from the CA frame by unsnapping the hooks (2 pcs.) of the
FPC locker.
(6) Disengage the carriage and the timing belt from the CA frame.
(7) The timing belt is held under the carriage. Clear the belt holding hook to remove
the timing belt from the carriage.
Fig. 4.37 Printer Mechanism