Service manual

REPAIR
Mechanical
SERVICE MANUAL
4-20
(2) Fit the LCD PCB into the LCD upper cover:
a) While holding the inverter PCB at an angle of 45
°
, slide its edge into hooks b.
Then, fit the inverter PCB into the LCD upper cover by prying hook a outwards.
The Inverter PCB is held in place by hook a and hooks b.
NOTE:
•
The inverter PCB is installed only in LW-810icBL and DP-550CJ/LW-840ic.
b) The procedure to install the LCD PCB differs according to the model.
<DP-525CJ/LW-800ic, DP-530CJ/LW-810ic, LW-810icBL>
While holding the LCD PCB at an angle of 45
°
, slide its edge into hooks B.
Then, fit the LCD PCB in the LCD upper cover by prying hooks A outwards.
The LCD PCB is held in place by hooks A and hooks B.
When installing the LCD PCB, determine the position by aligning the holes in
the LCD PCB with the bosses on the LCD upper cover.
NOTE:
•
The volume guide on the LCD PCB must fit properly with the projection of the LCD
volume knob attached to the LCD upper cover to allow the LCD volume knob to move
smoothly. See Fig. 4.15.
Finally, tighten the taptites.