Owner's Manual

Appendix ——————————————————————————————————————————————————————————

—

176

■ Removing the cap frame

After embroidering is finished, remove the cap

frame, and then remove the cap.

Remove the cap frame from the cap frame

driver.

Press both of the two holders at the base of the

cap frame with both thumbs, and then pull off

the embroidery frame, as shown in the

illustration.

1 Holder

As shown in the illustration, turn the

embroidering position to the side when

removing the cap frame so the brim of the cap

does not hit the embroidery machine.

• Be careful that the cap frame does not hit

any nearby parts, such as the presser foot.

Release the snap lock on the cap frame, and

then remove the cap.

Installing the embroidery

frame holder

After embroidering using the cap embroidery frame

is finished, remove the needle plate spacer and cap

frame driver, and then re-attach the embroidery

frame holder.

Remove the needle plate spacer.

1 Needle plate spacer

Loosen the two lower thumb screws.

1 Thumb screws

Remove the two upper thumb screws

1 Thumb screws

Sapphire.book Page 176 Friday, August 1, 2003 9:12 AM