Quick Start Manual

6 - 3 SETUP SEND
Manual and Automatic Fax Redial
If you’re sending a fax manually and the line is busy, press Redial/Pause to
try again. Anytime you want to make a second call to the last number dialed,
press Redial/Pause to save time.
If you’re sending a fax automatically and the line is busy, the FAX/MFC will
automatically redial (up to three times at 5 minute intervals).
Dual Access
You can scan up to 50 documents into the fax memory, even while the FAX/
MFC is receiving or sending another fax (from memory). You can set temporary
settings for each fax you’re scanning.
If you try to scan and store a 51st fax, the FAX/MFC will send it immediately
without storing it in memory.
1 Place the original face down in the ADF.
2 Enter the fax number.
3 Press Fax Start. As the FAX/MFC scans the original, the LCD shows the job
number (#XXX) of the fax and how much memory is available. Then the FAX/
MFC starts dialing. You can immediately repeat Steps 1 to 3 for the next fax.
Real Time Transmission
When you are sending a fax, the FAX/MFC will scan originals into memory before
sending them. Then, as soon as the phone line is free, the FAX/MFC will start dialing
and sending the fax. If memory becomes full, the FAX/MFC will send the document
in real time (even if REAL TIME TX is set to OFF).
Sometimes you may want to send an important document immediately, without
waiting for memory transmission. You can set REAL TIME TX to ON.
1 Place the original face down in the ADF.
2 Press Menu/Set, 2, 2, 6.
Note
If you get an OUT OF MEMORY message while scanning the first page of a
fax, press Stop/Exit to cancel scanning. If you get an OUT OF MEMORY
message while scanning a subsequent page, you’ll have the option to press
Fax Start to transmit the pages scanned so far or press Stop/Exit to cancel
the operation.
The number of pages you can scan into memory varies with the data they
contain.
6.REAL TIME TX