Service manual

4-1

Confidential

CHAPTER 4 ADJUSTING AND UPDATING

SETTINGS AS REQUIRED

AFTER PARTS

REPLACEMENT

1. IF YOU REPLACE THE MAIN PCB ASSY

 What to do after replacement

• Installing Firmware (Sub Firmware, Demo Firmware, and Main Firmware)

• Setting Default Paper Size (LED Models) / Setting by Spec (LCD Models)

• Setting Serial Number and Entering Adjusted Value of Laser Unit

 What you need to prepare

(1) One USB cable

(2) Create a temporary folder on the C drive of the computer (Windows

XP or later).

(3) Service setting tool (BrUsbsn.zip)

Copy this file into the temporary folder created on the C drive. Extract the copied file and

double-click "BrUsbsn.exe" to start it.

(4) Download utility (FILEDG32.EXE)

Copy this file into the temporary folder created on the C drive.

(5) Maintenance driver (MaintenanceDriver.zip)

When the maintenance driver is not installed on the computer, copy this file into the

temporary folder created on the C drive, and extract the copied file. Refer to “APPENDIX

3 INSTALLING THE MAINTENANCE PRINTER DRIVER” for the installation procedure.

(6) Firmware

PCL/PS-compliant model:

HL-L2360DN/2560DN/L2361DN/L2360DW/L2365DW/L2366DW

(7) Default paper size setting tool (SET_COUNTRYCODE.zip) (LED Models only)

Copy this file into the temporary folder created on the C drive.

Sub firmware

(PCL/PS-compliant model only)

LZXXXX_$.djf

Demo firmware (US model only) LZXXXX_$.djf

Main firmware LZXXXX_$.djf

LZXXXX : First six digits of the part number of the firmware

$: Alphabetic character representing the revision version of the firmware