Quick Reference Guide

21
i Lift the internal flap and slowly remove any
jammed material.
j Make sure you look carefully inside (1) for any
scraps of material.
k Using both hands, use the finger holds on each side
of the machine to lift the top cover (1) into the
open position.
l Slowly pull the jammed material (1) out of the
machine.
m Move the print head, and then remove any material
remaining in this area. Make sure pieces of material
are not left in the corners of the machine (1) and
(2).
IMPORTANT
• If the print head is in the right corner as shown in the
illustration, you cannot move the print head. Close the top
cover, and then reconnect the power cord. Open the top
cover again and then hold down until the print head
moves to the center. Then unplug the machine from the
power source and remove the material.
• If the material is jammed under the print head, unplug the
machine from the power source, and then move the print
head to take out the material.
• If ink gets on your skin or clothing, immediately wash it off
with soap or detergent.
1
1
1
21