Quick Reference Guide

20
Roll media Cutter is Jammed (Cutter Jam
01/02 )
If the LCD displays the following messages, follow these
steps:
•[Cutter Jam 01], [Cutter Jam 02]
a Unplug the machine from the AC power outlet.
b If the paper is loaded in the manual feed slot,
remove the paper.
c Pull Tray #1 (1) completely out of the machine as
shown by the arrow.
d Lift the paper support (1) and then pull it at an
angle completely out of the machine as shown by
the arrow.
e If your LCD displays [Cutter Jam 02], do the
following:
a. Open the lower Jam Clear Cover B (1) at the back of
the machine.
b. Manually slide the cutter unit (1) to the far right (home
position).
c. Close the lower Jam Clear Cover B. Make sure the
cover is closed completely.
f Slowly open the upper Jam Clear Cover A (1) at
the back of the machine.
This cover may feel heavier than usual, because the Fabric
Roll runs through the inside of the cover.
g Manually cut the fabric carefully, as shown.
hKeep the upper Jam Clear Cover A open, and then
go to the front of the machine.
1
1
1
1
1