Quick Reference Guide

17
Fabric Roll is Jammed in the Back of the
Machine
If the LCD displays the following messages, follow these
steps:
•[Roll Fabric Jam 01], [Roll Fabric Jam 02]
a Unplug the machine from the AC power outlet.
If your LCD displays [Roll Fabric Jam 02], open the
upper Jam Clear Cover A (1) at the back of the machine.
When finished, continue with the next step.
b Pull Tray #2 completely out of the machine as
shown by the arrow.
c Remove Fabric Roll from Tray #2 and roll up the
fabric.
If the feeding edge is folded, bent, or cut at an angle, cut it
straight across.
d Reload the Fabric Roll into Tray #2.
For details on loading, refer to “Load the Fabric Roll in
Tray #2” (P.8).
If your LCD displays [Roll Fabric Jam 02], close the
upper Jam Clear Cover A at the back of the machine. Make
sure the cover is closed completely.
When finished, continue with the next step.
e Slowly push Tray #2 completely into the machine.
f Reconnect the power cord.
Fabric Roll is Jammed Inside and in the
Back of the Machine
If the LCD displays the following messages, follow these
steps:
•[Roll Fabric Jam 03]
a Unplug the machine from the AC power outlet.
b If the paper is loaded in the manual feed slot,
remove the paper.
c Pull Tray #1 (1) completely out of the machine as
shown by the arrow.
d Lift the paper support (1) and then pull it at an
angle completely out of the machine as shown by
the arrow.
1
1
1