User`s guide

6-3
a If it is not already selected, select Queue Server mode.
b Click the Change Bindery Queues button.
c Select the Netware server which you wish to configure.
d Select the New Queue button and type in the queue name which you wish
to create.
e Once you have done that highlight the queue name you created an then click
on the Add button.
f Click on Close and then OK.
Now exit the BRAdmin32 application.
Configuring the Brother Print Server (Queue Server Mode in NDS mode) using
BRAdmin32
1. Make sure that you logged in as ADMIN in NDS mode.
2. Start the BRAdmin32 program.
3. One or more print server services will appear in the list of printers (the default node
names are BRN_xxxxxx, where "xxxxxx" is the last six digits of the Ethernet address
(MAC address)).
✒
Note
You can find the node name and MAC address by printing out the printer configuration page.
Refer to the Quick Setup Guide for information on how to print the configuration page on your
print server.
4. Select the printer that you wish to configure and double click it. You will be asked for a
password. The default password is "access".
5. Select the Netware tab.
✒
Note
If necessary change the “Print Server Name”, the default Netware print server name will be
BRN_xxxxxx_P1 where xxxxxx is the Ethernet address (MAC address) of the print server. Be
careful! Changing the name may impact the configuration of other protocols because the print
server service names will be altered.