User`s guide

IP Address Configuration
The final step before printing is to program the IP address information into the print server.
This can be done in any of the following ways:
a) BRAdmin32 (for Windows 95/98/NT 4.0 using the IPX/SPX or TCP/IP protocol)
b) DHCP, Reverse Arp (rarp), BOOTP
c) The UNIX arp command.
The following step (e, f, g) is effective way, when you change IP address. But a valid IP
address must already be programmed into the print server.
d) TELNET
e) HTTP (Web browser)
f) Other SNMP based management utility
These configuration methods are described in the following paragraphs.
✒ Note
The IP address you assign to the print server must be on the same logical network as your host
computers, if it is not, you must properly configure the subnet mask and the router (gateway).
Changing the IP Address using the BRAdmin32 application
Start the BRAdmin32 utility (from Windows 95/98 or NT4.0).