User`s guide
Table Of Contents
- TABLE OF CONTENTS
- Chapter 1 How to Configure TCP/IP printing for Unix Systems
- Chapter 2 How to Configure TCP/IP printing for Windows NT, LAN Server and OS/2 Warp Server
- Chapter 3 How to Configure Peer-to-Peer Printing for Windows 95/98
- Chapter 4 How to Configure Peer-to-Peer (NetBIOS) printing for Windows 95/98/NT, LAN Server and OS/2 Warp Server
- Chapter 5 How to Configure Brother Internet Print for Windows 95/98/NT
- Chapter 6 How to Configure Novell Netware printing using IPX/SPX
- General Information
- Creating a Print Queue Using BRAdmin32
- Configuring the Brother Print Server (Queue Server Mode in Bindery emulation mode) using BRAdmin32
- Configuring the Brother Print Server (Queue Server Mode in NDS mode) using BRAdmin32
- Configuring the Brother Print Server (Queue Server Mode in NDS mode) using Novell NWADMIN and BRAdmin32
- Configuring the Brother Print Server (Remote Server Mode in NDS mode) using Novell NWAdmin and BRAdmin32
- Configuring the Brother Print Server (Queue Server Mode in Bindery emulation mode) using PCONSOLE and BRCONFIG
- Configuring the Brother Print Server (Queue Server Mode in NDS mode) using PCONSOLE and BRCONFIG
- Configuring the Brother Print Server (Remote Printer Mode using PCONSOLE and BRCONFIG
- Testing the Print Queue
- Configuring the Workstation (DOS-based NetWare drivers)
- Configuring the Workstation (Windows 3.1x)
- Configuring the Workstation (Windows 95/98)
- Chapter 7 How to Configure Macintosh printing using Appletalk
- Chapter 8 How to Configure DLC/LLC printing for Windows NT
- Chapter 9 How to use the Web based management function
- Chapter 10 TROUBLESHOOTING
- Overview
- Installation problems
- Intermittent Problems
- TCP/IP Troubleshooting
- UNIX Troubleshooting
- Windows NT/LAN Server (TCP/IP) Troubleshooting
- Windows 95/98 Peer to Peer Print (LPR) Troubleshooting
- Windows 95/98 (or later) Peer-to-Peer (HP JetAdmin compatible method) Troubleshooting
- Windows 95/98/NT 4.0 Peer-to-Peer Print (NetBIOS) Troubleshooting
- Internet Print (TCP/IP) Troubleshooting
- Novell NetWare Troubleshooting
- AppleTalk Troubleshooting
- DLC/LLC Troubleshooting
- Web Browser Troubleshooting (TCP/IP)
- APPENDIX
- INDEX
A-14
3. Netware GET from a server
You must have a Netware server on your network (running IPX/SPX) and you must store
the new firmware file in the SYS/Login directory of the server. In this case, your PC
makes the print server read the firmware data from the assigned Netware server, the print
server attaches to the Netware server and reads the firmware itself..
The Data LED on the printer front panel will blink during the load process and will either go
out when the load has completed (on a 10Mbit network) or will stay lit when the printer is
connected to a 100Mbit network.
If the Data LED does not stop blinking after about two minutes, or blink periodically, check to
make sure that you correctly entered all parameters and that your network connections are
good. Then power the print server/printer off and then on again, to retry the download.