User`s guide
Table Of Contents
- TABLE OF CONTENTS
- Chapter 1 How to Configure TCP/IP printing for Unix Systems
- Chapter 2 How to Configure TCP/IP printing for Windows NT, LAN Server and OS/2 Warp Server
- Chapter 3 How to Configure Peer-to-Peer Printing for Windows 95/98
- Chapter 4 How to Configure Peer-to-Peer (NetBIOS) printing for Windows 95/98/NT, LAN Server and OS/2 Warp Server
- Chapter 5 How to Configure Brother Internet Print for Windows 95/98/NT
- Chapter 6 How to Configure Novell Netware printing using IPX/SPX
- General Information
- Creating a Print Queue Using BRAdmin32
- Configuring the Brother Print Server (Queue Server Mode in Bindery emulation mode) using BRAdmin32
- Configuring the Brother Print Server (Queue Server Mode in NDS mode) using BRAdmin32
- Configuring the Brother Print Server (Queue Server Mode in NDS mode) using Novell NWADMIN and BRAdmin32
- Configuring the Brother Print Server (Remote Server Mode in NDS mode) using Novell NWAdmin and BRAdmin32
- Configuring the Brother Print Server (Queue Server Mode in Bindery emulation mode) using PCONSOLE and BRCONFIG
- Configuring the Brother Print Server (Queue Server Mode in NDS mode) using PCONSOLE and BRCONFIG
- Configuring the Brother Print Server (Remote Printer Mode using PCONSOLE and BRCONFIG
- Testing the Print Queue
- Configuring the Workstation (DOS-based NetWare drivers)
- Configuring the Workstation (Windows 3.1x)
- Configuring the Workstation (Windows 95/98)
- Chapter 7 How to Configure Macintosh printing using Appletalk
- Chapter 8 How to Configure DLC/LLC printing for Windows NT
- Chapter 9 How to use the Web based management function
- Chapter 10 TROUBLESHOOTING
- Overview
- Installation problems
- Intermittent Problems
- TCP/IP Troubleshooting
- UNIX Troubleshooting
- Windows NT/LAN Server (TCP/IP) Troubleshooting
- Windows 95/98 Peer to Peer Print (LPR) Troubleshooting
- Windows 95/98 (or later) Peer-to-Peer (HP JetAdmin compatible method) Troubleshooting
- Windows 95/98/NT 4.0 Peer-to-Peer Print (NetBIOS) Troubleshooting
- Internet Print (TCP/IP) Troubleshooting
- Novell NetWare Troubleshooting
- AppleTalk Troubleshooting
- DLC/LLC Troubleshooting
- Web Browser Troubleshooting (TCP/IP)
- APPENDIX
- INDEX
A-13
1. TFTP PUT from this host
Use this method if you have TCP/IP already installed on your PC. BRAdmin32 will use
the TFTP protocol to send the new firmware data to the print server.
2. TFTP GET from a server
If you have a TFTP server installed in your network (many Unix systems provide TFTP
support), you may wish to use this option. The new firmware file must be located in the
TFTP BOOT directory on your TFTP server. In this case, your PC makes the print server
read the firmware data from the assigned TFTP server. If you do not provide the correct
file name, then the upgrade will fail. You must also ensure that the firmware file is set so
that the print server can read the file. On Unix systems you can use the chmod command to
specify file attributes. For example, chmod filename 666 allows the filename to be
accessed by anyone. Also make sure that the TFTP service is running on your Unix server.