User`s guide
Table Of Contents
- TABLE OF CONTENTS
- Chapter 1 How to Configure TCP/IP printing for Unix Systems
- Chapter 2 How to Configure TCP/IP printing for Windows NT, LAN Server and OS/2 Warp Server
- Chapter 3 How to Configure Peer-to-Peer Printing for Windows 95/98
- Chapter 4 How to Configure Peer-to-Peer (NetBIOS) printing for Windows 95/98/NT, LAN Server and OS/2 Warp Server
- Chapter 5 How to Configure Brother Internet Print for Windows 95/98/NT
- Chapter 6 How to Configure Novell Netware printing using IPX/SPX
- General Information
- Creating a Print Queue Using BRAdmin32
- Configuring the Brother Print Server (Queue Server Mode in Bindery emulation mode) using BRAdmin32
- Configuring the Brother Print Server (Queue Server Mode in NDS mode) using BRAdmin32
- Configuring the Brother Print Server (Queue Server Mode in NDS mode) using Novell NWADMIN and BRAdmin32
- Configuring the Brother Print Server (Remote Server Mode in NDS mode) using Novell NWAdmin and BRAdmin32
- Configuring the Brother Print Server (Queue Server Mode in Bindery emulation mode) using PCONSOLE and BRCONFIG
- Configuring the Brother Print Server (Queue Server Mode in NDS mode) using PCONSOLE and BRCONFIG
- Configuring the Brother Print Server (Remote Printer Mode using PCONSOLE and BRCONFIG
- Testing the Print Queue
- Configuring the Workstation (DOS-based NetWare drivers)
- Configuring the Workstation (Windows 3.1x)
- Configuring the Workstation (Windows 95/98)
- Chapter 7 How to Configure Macintosh printing using Appletalk
- Chapter 8 How to Configure DLC/LLC printing for Windows NT
- Chapter 9 How to use the Web based management function
- Chapter 10 TROUBLESHOOTING
- Overview
- Installation problems
- Intermittent Problems
- TCP/IP Troubleshooting
- UNIX Troubleshooting
- Windows NT/LAN Server (TCP/IP) Troubleshooting
- Windows 95/98 Peer to Peer Print (LPR) Troubleshooting
- Windows 95/98 (or later) Peer-to-Peer (HP JetAdmin compatible method) Troubleshooting
- Windows 95/98/NT 4.0 Peer-to-Peer Print (NetBIOS) Troubleshooting
- Internet Print (TCP/IP) Troubleshooting
- Novell NetWare Troubleshooting
- AppleTalk Troubleshooting
- DLC/LLC Troubleshooting
- Web Browser Troubleshooting (TCP/IP)
- APPENDIX
- INDEX
A-12
Appendix C
Reloading the Print Server Firmware
General
The firmware on the print server is stored in flash memory. This means that you can upgrade
the firmware by downloading the appropriate update file. To get the latest firmware update,
access the Brother WWW server on www.brother.com.
✒ Note
We recommend that you factory reset the print server if you upgrade to a later version of
software. Instructions on how to perform a factory reset can be found in the quick setup guide
that accompanies the print server.
Reloading from BRAdmin32 on the Windows
95/98/NT4.0
The BRAdmin32 utility can be used to easily re-program your Brother print server.
Start the BRAdmin32 software.
Highlight the appropriate print server. Then press select the Control menu and choose Load
Firmware. You can select more than one print server by pressing CTRL+<select> or
SHIFT+<select> on each additional print server.
There are three possible ways of sending the new software version to the print server. For
which ever method you select, you must enter a password for the print server. The default
password for the print server is “access”.