Barcode Reference Guide
Table Of Contents
- Barcode Reference Guide
- Introduction
- Quick reference for barcode control commands
- Print barcodes or expanded characters
- Definition of parameters
- Barcode mode
- Barcode, expanded character, line block drawing and box drawing
- Barcode
- Barcode human readable line ON or OFF
- Quiet zone
- Barcode, expanded character unit, line block drawing and box drawing
- Barcode, expanded character, line block drawing and box drawing offset in X-axis
- Barcode & expanded character offset in Y-axis
- Barcode, expanded character, line block drawing and box drawing height
- Expanded character width, line block drawing and box drawing
- Expanded character rotation
- Barcode data start
- Box drawing
- Line block drawing
- Expanded character data start
3
Quick reference for barcode control commands
2
Barcode, expanded character, line block drawing and box drawing 2
This parameter chooses the barcode style as above. When the EAN 8, EAN 13, UPC-A, Code 128 or EAN
128 barcode mode is chosen, this barcode style parameter is ignored.
Expanded Character
‘S’
0 = White
1 = Black
2 = Vertical stripes
3 = Horizontal stripes
4 = Cross hatch
For example ‘S’ n1 n2
n1 = Background fill pattern
n2 = Foreground fill pattern
If ‘S’ is followed by only one parameter, the parameter is a foreground fill pattern.
Line block drawing & box drawing
‘S’
1 = Black
2 = Vertical stripes
3 = Horizontal stripes
4 = Cross hatch
Barcode 2
n = ‘mnnn’ or ‘Mnnn’ (nnn = 0 ~ 32767)
This parameter shows the barcode width. The unit of ‘nnn’ is a percentage.
n = ‘s0’ or ‘S0’ 3: 1 (default)
n = ‘s1’ or ‘S1’ 2: 1
n = ‘s3’ or ‘S3’ 2.5: 1