Quick Setup Guide

27
For Wireless Network Users
Wireless Network
Windows
®
Macintosh
One push configuration using Wi-Fi Protected Setup or AOSS™
11
Configure the wireless
settings
a Confirm your WLAN access point/router has
the Wi-Fi Protected Setup or AOSS™ symbol
as shown below.
b Place the Brother machine within range of your
Wi-Fi Protected Setup or AOSS™ access
point/router. The range may differ depending
on your environment. Refer to the instructions
provided with your access point/router.
c Press any of the Menu buttons (+, -, OK or
Back) of the control panel on your machine.
Press + or - to choose Network, WLAN or
SES/WPS/AOSS. And then, press OK.
The machine searches for an access point that
supports Wi-Fi Protected Setup or AOSS™ for
2 minutes.
d Push the Wi-Fi Protected Setup or AOSS™
button on your WLAN access point/router. See
the user’s guide for your WLAN access
point/router for instructions.
This feature will automatically detect which
mode (Wi-Fi Protected Setup or AOSS™) your
access point/router uses to configure your
machine.
e If the LCD shows Connected, the printer has
successfully connected to your access
point/router. You can now use your printer in a
wireless network.
If the LCD shows Connection Error, a
session overlap has been detected. The printer
has detected more than one access
point/router on your network with the Wi-Fi
Protected Setup mode or AOSS™ mode
enabled. Make sure that only one access
point/router has the Wi-Fi Protected Setup
mode or the AOSS™ mode enabled and try
starting from c again.
If the LCD shows No Access Point, the
printer has not detected your access
point/router on your network with the Wi-Fi
Protected Setup mode or AOSS™ mode
enabled. Move the printer closer to your access
point/router and try starting from c again.
If the LCD shows Connection Fail, the
printer has not successfully connected to your
access point/router. Try starting from c again.
If the same message is indicated again, reset
the print server back to its factory default
settings and try again. For resetting, see Reset
the network settings to the factory
default on page 32.
To install the printer driver, continue to;
For Windows
®
Users:
Now go to
step 12 on page 28
For Macintosh Users:
Now go to
step 12 on page 30
Note
If your wireless access point/router supports
Wi-Fi Protected Setup
(PIN Method) and you want
to configure your machine using the PIN
(Personal Identification Number) Method, see
How to configure your wireless machine, using
the PIN Method of Wi-Fi Protected Setup in the
Network User's Guide.
Wireless setup is now complete. A four
level indicator at the right of your
machine’s LCD will show the wireless
signal strength of your access
point/router.