Printer User Manual
Table Of Contents
- USER’S GUIDE HL-2130 HL-2132 HL-2135W HL-2220 HL-2230 HL-2240 HL-2240D HL-2242D HL-2250DN HL-2270DW
- Using this guide
- Table of Contents
- 1 Printing Methods
- 2 Driver and Software
- Printer driver
- Features in the printer driver (for Windows®)
- Basic tab
- Paper Size
- Orientation
- Copies
- Media Type
- Resolution
- Print Settings
- Multiple Page
- Duplex / Booklet
- Paper Source
- Advanced tab
- Scaling
- Reverse Print
- Use Watermark
- Header-Footer Print
- Toner Save Mode
- Administrator
- Other Print Options...
- Use Reprint
- Sleep Time
- Macro (HL-2250DN / HL-2270DW only)
- Density Adjustment
- Error Message Printout
- Improve Print Output
- Skip Blank Page
- Print Profiles tab
- Support
- Tray Settings
- Status Monitor
- Features in the printer driver (for Macintosh)
- Features in the printer driver (for Windows®)
- Uninstalling the printer driver
- Software
- Printer driver
- 3 Control Panel
- 4 Routine Maintenance
- 5 Troubleshooting
- A Appendix
- Machine specifications
- Symbol and character sets (HL-2250DN / HL-2270DW only)
- Quick reference for bar code control commands (HL-2250DN / HL-2270DW only)
- Print bar codes or expanded characters
- Definition of parameters
- Bar code mode
- Bar code, expanded character, line block drawing and box drawing
- Bar code
- Bar code human readable line ON or OFF
- Quiet zone
- Bar code, expanded character unit, line block drawing and box drawing
- Bar code, expanded character, line block drawing and box drawing offset in X-axis
- Bar code & expanded character offset in Y-axis
- Bar code, expanded character, line block drawing and box drawing height
- Expanded character width, line block drawing and box drawing
- Expanded character rotation
- Bar code data start
- Box drawing
- Line block drawing
- Expanded character data start
- Table of Code (EAN) 128 set C
- Print bar codes or expanded characters
- B Appendix (for Europe and Other Countries)
- C Appendix (for USA and Canada)
- Index
Routine Maintenance
89
4
g Using both hands, slide the manual feed paper guides to the width of the paper that you are going to use.
h Using both hands, put one piece of A4 or Letter size paper in the manual feed slot until the top edge of
the paper touches the paper feed roller. When you feel the machine pull in the paper, let go. The machine
will start the Drum Cleaning process. The Ready LED flashes during the Drum Cleaning process.
Note
• The machine makes a mechanical noise during the Drum Cleaning process because the machine rotates
the OPC drum in reverse. This noise is not due to a malfunction of the machine.
• DO NOT put more than one sheet of paper in the manual feed slot at any one time, as it may cause a jam.
• If the paper in the manual feed slot is other than A4 or Letter size, the machine will stop the Drum Cleaning
process and eject the paper.
• Make sure that the paper is straight and in the proper position on the manual feed slot. If it is not, it may
not be fed properly, resulting in a skewed printout or a paper jam.
• DO NOT close the back cover (face-up output tray) during the Drum Cleaning process. The machine will
stop the Drum Cleaning process and eject the paper. It may cause a jam.
• If the machine receives a print job before you put the sheet of paper in the manual feed slot, the machine
will stop the Drum Cleaning process and print the print job.