Printer User Manual
Table Of Contents
- USER’S GUIDE HL-2130 HL-2132 HL-2135W HL-2220 HL-2230 HL-2240 HL-2240D HL-2242D HL-2250DN HL-2270DW
- Using this guide
- Table of Contents
- 1 Printing Methods
- 2 Driver and Software
- Printer driver
- Features in the printer driver (for Windows®)
- Basic tab
- Paper Size
- Orientation
- Copies
- Media Type
- Resolution
- Print Settings
- Multiple Page
- Duplex / Booklet
- Paper Source
- Advanced tab
- Scaling
- Reverse Print
- Use Watermark
- Header-Footer Print
- Toner Save Mode
- Administrator
- Other Print Options...
- Use Reprint
- Sleep Time
- Macro (HL-2250DN / HL-2270DW only)
- Density Adjustment
- Error Message Printout
- Improve Print Output
- Skip Blank Page
- Print Profiles tab
- Support
- Tray Settings
- Status Monitor
- Features in the printer driver (for Macintosh)
- Features in the printer driver (for Windows®)
- Uninstalling the printer driver
- Software
- Printer driver
- 3 Control Panel
- 4 Routine Maintenance
- 5 Troubleshooting
- A Appendix
- Machine specifications
- Symbol and character sets (HL-2250DN / HL-2270DW only)
- Quick reference for bar code control commands (HL-2250DN / HL-2270DW only)
- Print bar codes or expanded characters
- Definition of parameters
- Bar code mode
- Bar code, expanded character, line block drawing and box drawing
- Bar code
- Bar code human readable line ON or OFF
- Quiet zone
- Bar code, expanded character unit, line block drawing and box drawing
- Bar code, expanded character, line block drawing and box drawing offset in X-axis
- Bar code & expanded character offset in Y-axis
- Bar code, expanded character, line block drawing and box drawing height
- Expanded character width, line block drawing and box drawing
- Expanded character rotation
- Bar code data start
- Box drawing
- Line block drawing
- Expanded character data start
- Table of Code (EAN) 128 set C
- Print bar codes or expanded characters
- B Appendix (for Europe and Other Countries)
- C Appendix (for USA and Canada)
- Index
Control Panel
58
3
Service call indications 3
If there is an error that cannot be cleared by the user, the machine will show that a service call is needed by
lighting up all the LEDs as shown below.
If you see the service call indication shown above, turn off the power switch, and then turn it back on and try
to print again.
If the error is not cleared after turning the power switch off and then back on, press Go, the LEDs will light up
as shown in the table below to identify the error.
1
If this error occurs, turn off the machine's power switch, wait a few seconds, and then turn it on again. Leave the machine for approx.15 minutes
with the power on. If the error occurs again, call your dealer or Brother Customer Service.
For example, the LED indication below shows a fuser unit failure.
Make a note of the indication, referring to the table on page 58, and report the error status to your dealer or
Brother Customer Service.
LED error indication
LEDs Main PCB
failure
Fuser unit
failure
1
Laser unit
failure
Main motor
failure
High voltage
failure
FAN Failure Zero Cross
Error
Toner
Drum
Error
Ready