Printer User Manual
Table Of Contents
- USER’S GUIDE HL-2130 HL-2132 HL-2135W HL-2220 HL-2230 HL-2240 HL-2240D HL-2242D HL-2250DN HL-2270DW
- Using this guide
- Table of Contents
- 1 Printing Methods
- 2 Driver and Software
- Printer driver
- Features in the printer driver (for Windows®)
- Basic tab
- Paper Size
- Orientation
- Copies
- Media Type
- Resolution
- Print Settings
- Multiple Page
- Duplex / Booklet
- Paper Source
- Advanced tab
- Scaling
- Reverse Print
- Use Watermark
- Header-Footer Print
- Toner Save Mode
- Administrator
- Other Print Options...
- Use Reprint
- Sleep Time
- Macro (HL-2250DN / HL-2270DW only)
- Density Adjustment
- Error Message Printout
- Improve Print Output
- Skip Blank Page
- Print Profiles tab
- Support
- Tray Settings
- Status Monitor
- Features in the printer driver (for Macintosh)
- Features in the printer driver (for Windows®)
- Uninstalling the printer driver
- Software
- Printer driver
- 3 Control Panel
- 4 Routine Maintenance
- 5 Troubleshooting
- A Appendix
- Machine specifications
- Symbol and character sets (HL-2250DN / HL-2270DW only)
- Quick reference for bar code control commands (HL-2250DN / HL-2270DW only)
- Print bar codes or expanded characters
- Definition of parameters
- Bar code mode
- Bar code, expanded character, line block drawing and box drawing
- Bar code
- Bar code human readable line ON or OFF
- Quiet zone
- Bar code, expanded character unit, line block drawing and box drawing
- Bar code, expanded character, line block drawing and box drawing offset in X-axis
- Bar code & expanded character offset in Y-axis
- Bar code, expanded character, line block drawing and box drawing height
- Expanded character width, line block drawing and box drawing
- Expanded character rotation
- Bar code data start
- Box drawing
- Line block drawing
- Expanded character data start
- Table of Code (EAN) 128 set C
- Print bar codes or expanded characters
- B Appendix (for Europe and Other Countries)
- C Appendix (for USA and Canada)
- Index
Troubleshooting
105
5
Paper jams and how to clear them 5
If a paper jam occurs, the machine will flash the Error LED as shown below.
WARNING
HOT SURFACE
• After you have just used the printer, some internal parts will be extremely hot. Wait at least 10 minutes
for the machine to cool down.
• To prevent any degradation to the print quality, DO NOT touch the shaded parts shown in the
illustrations.
Clear the jammed paper as follows.
If the jammed paper is removed completely by following the steps below, you can install the paper tray first,
and then close the front cover. The machine will resume printing automatically.
If the machine does not start printing automatically, press Go. If the machine still does not start printing, check
that all the remaining jammed paper has been removed from the machine. Then try printing again.