Owner's Manual

S-7200B
8. USING THE CONTROL BOX PANEL (ADVANCED OPERATIONS)
34
8-6. Setting the needle up stop position and needle down stop position
Meaning of displays during setting
• The stop position is set numerically, and “A”
to “F” represent the numbers “10” to “15”
respectively.
• A setting value of “8” corresponds to an
angle of rotation of approximately 8° for the
upper shaft.
<Needle up stop position>
1
(Example: -8)
1. Press the start backtack key (4) so that “
¯ ” is displayed
in the top row of the stitch number display.
2. Press the end backtack key (2) to set the value.
2
Set DIP switch -3 to ON.
(The settings will be locked.)
<Needle down stop position>
1
(Example: 3)
1. Press the start backtack key (4) so that “- ” is displayed
in the top row of the stitch number display.
2. Press the end backtack key (2) to set the value.
2
Set DIP switch -3 to ON.
(The settings will be locked.)
Display A b c d E F
Value 10 11 12 13 14 15
Becomes higher
Becomes lower
Becomes higher
Becomes lower
3151M
Becomes lower
Becomes higher
3657M
3152M