Owner's Manual

4. INSTALLATION

RH-9820

4-1-2. When embedding into the table

When embedding the machine head into the table, some extra components will be required, so contact the place of purchase

for further details.

NOTE:

When embedding the machine head into the table, be sure to install the L-shaped table reinforcement plates. (Refer to “4-3.

Installing the table reinforcement plates (embedded installation only)”.)

0339B

For control box

4 x 4 mm dia.

20 depth

(From underneath

table)

For valve unit

For cotton stand

For pneumatic unit

Shaded area should

be C10

For table le

Melamine veneer

anel

2x 2mm dia. 10 depth

(from underneath

table)

For power switch

For operation panel

4 x 2 mm dia. 10 depth

For o

eration

anel cord

For bed su

ort

late

For L-sha

ed reinforcement

lates