Operation Manual
Table Of Contents
- ADVANCED USER’S GUIDE DCP-J515W DCP-J715W
- User's Guides and where do I find it?
- Table of Contents
- 1 General setup
- 2 Printing reports
- 3 Making copies
- Copy settings
- Stop copying
- Changing copy speed and quality
- Enlarging or reducing the copied image
- Making N in 1 copies or a poster (Page Layout)
- Sorting copies using the ADF (DCP-J715W only)
- Adjusting Density
- Ink Save Mode
- Book Copy
- Watermark Copy
- Setting your changes as a new default
- Restoring all settings to the factory settings
- Copy settings
- 4 Printing photos from a memory card or USB Flash memory drive
- 5 Printing photos from a camera (DCP-J715W only)
- A Routine maintenance
- B Glossary
- Index
- brother UK/IRE/GEN
Making copies
11
3
Setting your changes as a
new default 3
You can save the copy settings for Quality,
Enlarge/Reduce, Density,
Ink Save Mode and Page Layout that
you use most often by setting them as the
default settings. These settings will stay until
you change them again.
a Press a or b and d or c to choose your
new setting.
Press OK.
Repeat this step for each setting you
want to change.
b After changing the last setting, press
a or b to choose Set New Default.
Press OK.
c Press + to choose Yes.
d Press Stop/Exit.
Restoring all settings to the
factory settings 3
You can restore the copy settings Quality,
Enlarge/Reduce, Density,
Ink Save Mode, and Page Layout, that
you have changed, to the factory settings.
a Press a or b to choose
Factory Reset.
Press OK.
b Press + to choose Yes.
c Press Stop/Exit.