Installation Instructions

LX6274004
UK/IRE/GEN
Printed in China
Before you can use the machine, read this Quick Setup Guide
for the correct setup and installation.
Turn the sheet over.
Quick Setup Guide
DCP-J125
Install the ink cartridges
5
d. Unpack the ink cartridge.
Turn the green knob on the protective yellow cap clockwise until it clicks to release the vacuum
seal, then remove the cap a.
If all lines are clear and visible, o
press (Yes) to finish the quality
check.
If you can see missing short lines, o
press
(No) and follow the steps
on the LCD.
Set the LCD contrast (if needed)
76
Check the print quality
c. Remove the green protective part a.
OK
Poor
Set the date and time
8
a. Press Menu.
b. Press a or b to choose
General Setup, and then press OK.
c. Press a or b to choose
LCD Settings, and press OK.
d. Press a or b to choose
LCD Contrast, and then press OK.
e. Press d or c to choose the contrast level,
and then press OK.
f. Press Stop/Exit.
a. Press Menu.
b. Press a or b to choose
Initial Setup, and
then press OK.
c. Press a or b to choose
Date&Time, and then
press OK.
Unpack the machine and check the components
1
1
Inbox Ink Cartridges [x4]
1
Black
Yellow
Cyan
Magenta
Power Cord
Installation CD-ROM
Documentation CD-ROM
Quick Setup Guide Basic User’s Guide
Safety and Legal booklet
1
Approx. 65% yield of the replacement cartridge. For details, see Consumable items in the Basic User’s Guide.
Plastic bags are used in the packaging of your machine. To avoid danger of
suffocation, please keep these bags away from babies and children.
WARNING
2
a. Pull out the paper tray. b. Lift the output paper tray cover a.
Load plain A4 paper
c. Press and slide the
paper side guides
a and paper length
guide b to fit the
paper size.
Make sure that the
triangular marks c
on the paper side
guides a and paper
length guide b line
up with the mark for
the paper size you
are using.
d. Fan the stack of paper well.
e. Gently put the paper into the paper tray.
Check that the paper is flat in the tray.
f. Gently adjust the paper side guides to
the paper with both hands.
Make sure the paper side guides touch
the edges of the paper.
g. Close the output paper tray
cover and slowly push the
paper tray back into the
machine.
h. Pull out the paper support a
until it clicks, and then unfold
the paper support flap b.
IMPORTANT
DO NOT push the paper in too far.
a. Connect the power cord.
The machine must be fi tted with an earthed plug.
WARNING
Connect the power cord
3
Choose your language
4
a. Press a or b to choose your language and press OK.
b. Press a or b to choose Yes or No and press OK.
Note
If you set the wrong language, you can change it again
after setting the date and time.
(For details see Changing LCD language in chapter 1 in
the Advanced User’s Guide on the documentation
CD-ROM.)
e. Install each ink cartridge in the direction of the arrow on the label.
Take care to match the colour of the lever a with the cartridge
colour b.
Start Here
WARNING
WARNING indicates a
potentially hazardous
situation which, if not
avoided, could result in
death or serious injuries.
a. The LCD shows No Ink Cartridge.
b. Open the ink cartridge cover a.
a. When the preparation process has
finished, the LCD shows
Set Paper and Press Start.
Press Colour Start.
Note
The components of your box may differ depending on your •
country.
Save all packing materials and the box in case for any •
reason you must ship your machine.
A USB cable is not included. •
You need to purchase a USB 2.0 cable that is no more
than 2 metres long.
a. Remove the protective tape and film covering the
machine, and also from the LCD.
b. Remove the plastic bag a containing the ink cartridges
from on top of the paper tray.
c. Make sure you have all components.
f. Gently push the ink cartridge until it clicks. After all the ink
cartridges are installed close the ink cartridge cover.
d. To enter the last two digits of the year, press
a, b, d or c to select a number and press OK.
To save the year, press a, b, d or c to select
OK
OK
and press OK.
OK
OK
0
1 23
45
6
789
Year:2010
(e.g. Enter 10 for 2010.)
IMPORTANT
DO NOT connect the USB cable yet.
Note
The Warning LED on the control panel
will stay on until you have installed the
ink cartridges.
Note
Make sure you install the Inbox Ink Cartridges
included with your machine fi rst.
e. Repeat for month/day/time in 24-hour format.
f. Press Stop/Exit.
Note
If you make a mistake and want to start again,
press Stop/Exit to go back to step a.
b. Check the quality of the four colour blocks a
on the sheet.
(black/yellow/cyan/magenta)
Note
Do not throw away the green protective part.
You will need it if you transport the machine.
Note
The machine will prepare the ink tube system for printing.
This process will take approximately four minutes.
Do not turn off the machine.
1
1
2
1
1
1
2
1
1
3
2
3
1