Quick Start Manual
Table Of Contents
- Quick Setup Guide DCP-J100 DCP-J105
- Start Here
- For Windows® USB interface users (Windows® XP Home/XP Professional/Windows Vista®/Windows® 7/Windows® 8)
- For Macintosh USB interface users (Mac OS X v10.6.8, 10.7.x, 10.8.x)
- For wireless network interface users (DCP-J105 only)
- 11 Before you begin
- 12 Choose your wireless setup method
- 13 Setup using the CD-ROM (Windows® and Macintosh)
- 13 Manual setup from the control panel using the Setup Wizard (Windows®, Macintosh and mobile devices)
- 13 One-push setup using WPS or AOSS™ (Windows®, Macintosh and mobile devices)
- Install the drivers and software (Windows® XP Home/XP Professional/Windows Vista®/Windows® 7/Windows® 8)
- Install the drivers and software (Mac OS X v10.6.8, 10.7.x, 10.8.x)
- Install Optional Applications Windows®
- For Network Users
- Other Information
- brother CEE-ENG
4
f Gently push the back of the ink cartridge
marked “PUSH” until the cartridge lever lifts.
After all the ink cartridges are installed, close
the ink cartridge cover.
6
Load plain A4 paper
a Pull the paper tray completely out of the
machine.
b Open the output paper tray cover.
c Gently press and slide the paper width
guides a and then the paper length guide b to
fit the paper size.
Make sure that the triangular marks c on the
paper width guides a and paper length
guide b line up with the mark for the paper size
you are using.
d Fan the stack of paper well to avoid paper jams
and misfeeds.
e Gently put the paper into the paper tray print
side down and top edge first. Check that the
paper is flat in the tray.
NOTE
The machine will prepare the ink tube system for
printing. This process will take approximately four
minutes. Do not turn off the machine. We
recommend you perform the next step while
waiting.
1
2
3
3
NOTE
Always make sure that the paper is not curled or
wrinkled.
IMPORTANT
Be careful that you do not push the paper in too
far; it may lift at the back of the tray and cause
paper feed problems.