User Manual

50
Fuser Error The temperature of the fuser unit
does not rise at a specified
temperature within a specified time.
Turn the power switch off, wait a few seconds,
and then turn it on again. Leave the machine for
15 minutes with the power on.
The fuser unit is too hot.
No Paper The machine is out of paper or
paper is not properly loaded in the
paper tray.
Do one of the following:
 Refill the paper in the paper tray or MP tray.
 Remove the paper and load it again.
No Tray The paper tray is not completely
closed.
Close the paper tray properly.
Out of Memory The machine’s memory is full. Copy operation in progress
Do one of the following:
 Press Start to copy the scanned pages.
 Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
Printing operation in process
Do one of the following:
 Reduce print resolution. (See Advanced tab
in the Software User’s Guide on the
CD-ROM.)
 Turn on the Page Protection function. (See
Device Options in the Software User’s Guide
on the CD-ROM.)
 Clear the data from the memory by pressing
Job Cancel.
Paper Jam
Back
The paper is jammed in the back of
the machine.
(See Paper jams on page 53.)
Paper Jam
Inside
The paper is jammed inside the
machine.
(See Paper jams on page 53.)
Paper Jam
MPTray
The paper is jammed in the MP tray
of the machine.
(See Paper jams on page 53.)
Paper Jam
Tray1
Paper Jam
Tray2
The paper is jammed in the paper
tray of the machine.
(See Paper jams on page 53.)
Replace Fuser It is time to replace the fuser unit. Call Brother Customer Service to replace the
fuser unit.
Replace Laser It is time to replace the laser unit. Call Brother Customer Service to replace the
laser unit.
Replace PF
Kit1
It is time to replace the paper
feeding kit for Tray 1.
Call Brother Customer Service to replace the PF
Kit 1.
Replace PF
Kit2
It is time to replace the paper
feeding kit for Tray 2.
Call Brother Customer Service to replace the PF
Kit 2.
Error Message Cause Action