Owner's Manual
Table Of Contents
- Top Page
- Network User’s Guide
- USER'S GUIDE DCP-8040 DCP-8045D
- Brother numbers
- Ordering accessories and supplies
- Safety precautions
- Choosing a location
- Table of Contents
- 1 Introduction
- 2 Paper
- 3 On-screen programming
- 4 Getting started
- 5 Making copies
- 6 Using the DCP as a printer
- 7 Printer driver settings
- 8 How to scan using Windows®
- Scanning a document
- Scanning a document (For Windows® XP only)
- Using the scan key (For USB or Parallel interface cable users)
- Using ScanSoft® PaperPort® and OmniPage® OCR
- 9 Using the Brother Control Center (For Windows® 98/98SE/Me/2000 Professional and Windows NT® WS 4.0)
- 10 Using the Windows®-Based Brother SmartUI Control Center (For Windows® XP)
- 11 Using your DCP with a Macintosh®
- Setting up your USB-equipped Apple® Macintosh®
- Using the Brother printer driver with your Apple® Macintosh® (Mac OS® 8.6 - 9.2)
- Using the Brother Printer Driver with Your Apple® Macintosh® (Mac OS® X)
- Using the PS driver with your Apple® Macintosh®
- Using the Brother TWAIN scanner driver with your Macintosh®
- Using Presto!® PageManager®
- 12 Network Scanning (Windows® 98/98SE/Me/2000 Professional and XP only)
- 13 Important information
- 14 Troubleshooting and routine maintenance
- 15 Optional accessories
- Glossary
- Specifications
- Index
- brother USA
1 - 8 INTRODUCTION
Status LED indications
The
Status
LED (Light Emitting Diode) will flash and change color
depending on the DCP status.
The LED indications shown in the table below are used in the
illustrations in this chapter.
LED LED status
LED is off.
Green Yellow Red
LED is on.
Green Yellow Red
LED is blinking.
LED DCP status Description
Sleep Mode The power switch is off or the DCP is in Sleep
mode or Power save mode.
Green
Warming Up The DCP is warming up for printing.
Green
Ready The DCP is ready to print.
Yellow
Receiving Data The DCP is either receiving data from the
computer, processing data in memory or
printing data.
Yellow
Data Remaining in
Memory
Print data remains in the DCP memory.