Owner's Manual
Table Of Contents
- Top Page
- Network User’s Guide
- USER'S GUIDE DCP-8040 DCP-8045D
- Brother numbers
- Ordering accessories and supplies
- Safety precautions
- Choosing a location
- Table of Contents
- 1 Introduction
- 2 Paper
- 3 On-screen programming
- 4 Getting started
- 5 Making copies
- 6 Using the DCP as a printer
- 7 Printer driver settings
- 8 How to scan using Windows®
- Scanning a document
- Scanning a document (For Windows® XP only)
- Using the scan key (For USB or Parallel interface cable users)
- Using ScanSoft® PaperPort® and OmniPage® OCR
- 9 Using the Brother Control Center (For Windows® 98/98SE/Me/2000 Professional and Windows NT® WS 4.0)
- 10 Using the Windows®-Based Brother SmartUI Control Center (For Windows® XP)
- 11 Using your DCP with a Macintosh®
- Setting up your USB-equipped Apple® Macintosh®
- Using the Brother printer driver with your Apple® Macintosh® (Mac OS® 8.6 - 9.2)
- Using the Brother Printer Driver with Your Apple® Macintosh® (Mac OS® X)
- Using the PS driver with your Apple® Macintosh®
- Using the Brother TWAIN scanner driver with your Macintosh®
- Using Presto!® PageManager®
- 12 Network Scanning (Windows® 98/98SE/Me/2000 Professional and XP only)
- 13 Important information
- 14 Troubleshooting and routine maintenance
- 15 Optional accessories
- Glossary
- Specifications
- Index
- brother USA
NETWORK SCANNING (WINDOWS
®
98/98SE/ME/2000 PROFESSIONAL AND XP ONLY)
12 - 6
Scan to Image
When you select Scan to Image your original will be scanned and
sent directly to the PC you designated on your network. The Brother
SmartUI will activate the default graphics application on the
designated PC. You can change the
Scan
configuration. (For
Windows
®
98/Me/2000: See
Scan to Image
on page 9-14.) (For
Windows
®
XP: See
Hardware Section: Changing the Scan to button
configuration on page 10-5 to 10-10.)
1
Place the original face up in the ADF, or face down on the
scanner glass.
2
Press
Scan
.
3
Press or to select
Scan
to Image
.
Press
Set
.
4
Press or to select a
destination you want to send.
Press
Set
.
If the LCD prompts you to enter a PIN Number, enter the 4-digit
PIN Number for the destination PC on the control panel.
Press
Set
.
The DCP will start the scanning process.
For Network Scanning the Brother Control Center (SmartUI)
selections are used only for configuring the
Scan
button. You
will not be able to initiate a Network scan from the Brother
Control Center (SmartUI).
▲
Scan to E-mail
Scan to Image
Scan to OCR
▼
Scan to File
Select
▲▼
& Set