User Manual
Table Of Contents
- USER'S GUIDE DCP-8040/DCP-8045D
- "EC" Declaration of Conformity
- Safety precautions
- Choosing a location
- Table of Contents
- 1 Introduction
- 2 Paper
- 3 On-screen programming
- 4 Getting started
- 5 Making copies
- 6 Important information
- 7 Troubleshooting and routine maintenance
- 8 Optional accessories
- Glossary
- Specifications
- Index
- brother UK/IRE/SAF/PAN NORDIC
INTRODUCTION 1 - 9
Red
Service error Follow the steps below.
1. Turn off the power switch.
2. Wait a few seconds, and then turn it back on
and try to print again.
If you cannot clear the error and see the same
service call indication after turning the DCP
back on, call your dealer or Brother authorized
service center.
Red
Cover open The cover is open. Close the cover. (See
Error
messages on page 7-1.)
Toner empty Replace the toner cartridge with a new one.
(See Replacing the toner cartridge on page
7-24.)
Paper error Put paper in the tray or clear the paper jam.
Check the LCD message. (See Troubleshooting
and routine maintenance
on page 7-1.)
Scan lock Check that the scanner lock lever is released.
(See Scanner Lock Lever on page 1-5.)
Others Check the LCD message. (See Troubleshooting
and routine maintenance on page 7-1.)
Out of memory Memory is full. (See
Error messages
on page
7-1.)
LED DCP status Description