Service manual
2-40
Confidential
■ Error code 63
The toner cartridge reached the end of life. (Continue mode off)
■ Error code 64
These errors do not usually occur in the normal use. The conceivable causes are noise around
the installation site, fluctuation of the power supply voltage, and failures in the software.
Error, which cannot be specified, occurs.
Error code 65
Error, which cannot be specified, occurs.
Error code 66
Error, which cannot be specified, occurs.
Replace Toner
Open the Front Cover, replace Toner Cartridge.
<User Check>
• Replace a new toner cartridge.
• Press the [MENU] button. Next, press the [1] button and [8] button to clear the stop
mode*, and shift to the continue mode.
Step Cause Remedy
1
New toner actuator catching on
some position
Correct the position of the new toner
actuator.
2
Harness connection failure of new
toner sensor PCB
Check the harness connection of the new
toner sensor PCB and reconnect it.
3 New toner sensor PCB failure Replace the new toner sensor PCB.
4 Main PCB failure Replace the main PCB ASSY.
CAUTION :
• “REPLACE TONER” message in the state of leaved a few toner to improve a print
quality. Compared with this, the continue mode is that the machine continues printing
until the toner life end.
Toner Low
Prepare New Toner Cartridge.
Toner Low
Prepare New Toner Cartridge.
Toner Low
Prepare New Toner Cartridge.
<User Check>
• Turn OFF the power switch, and turn it ON again after a while.
Step Cause Remedy
1 Main PCB failure Replace the main PCB ASSY.