Service manual

5-42
Confidential
2.4 Continue mode / Stop mode settings of Toner cartridge
You can set the machine to continue printing after the LCD shows “Replace Toner”. The
machine will continue printing until the LCD shows “Toner Ended”. The default setting is
“Stop”.
<Models with numeric keys>
(1) Press the Menu button, and then press the 1, 8 in this order.
(2) Press the or button to choose continue or stop.
(3) Press the OK button.
(4) Press the Stop/Exit button, the machine goes back to the ready states.
<Models without numeric keys>
(1) Press the Menu button.
(2) Press the or button, then the “1. General Setup” will appear on the LCD and press
the OK button.
(3) Press the or button, then the “4. Replace Toner” will appear on the LCD and press
the OK button.
(4) Press the or button, then select the “Continue” or “Stop” and press the OK button.
(5) Press the Stop/Exit button, the machine goes back to the ready states.
Note:
• Printing is not guaranteed in the continue mode.
• If the toner cartridge is replaced, the machine returns to the default setting.