Service manual

4-3 Confidential

1.2

Initialization of EEPROM of Main PCB ASSY (Maintenance Mode: Code 01)

Initialize the EEPROM in accordance with

"1.4.1 EEPROM parameter initialization (Function

code 01, 91)"

in Chapter 5.

1.3 Setting by Country (Maintenance Mode: Code 74)

Make appropriate settings by country in accordance with "1.4.20 Setting by country (Function

code 74)" in Chapter 5.

1.4 Setting the Serial Number

(1) Check that the machine is in the ready state, and then connect the USB cable.

(2) Double-click the “brmainte.exe” file (maintenance utility) which has been copied in the

temporary folder to start.

(3) Select “Input information” from Menu.

(4) Select the applicable model name.

(5) Check the port (USB) that the machine is connected through.

(6) Click “Serial No.” in the lower box. Enter the serial number (the fifteen digits) of the

machine into the box on the right hand side and click the OK button.

A confirmation window opens and shows the serial number. Check that it is correct and

click the OK button.

Note:

• The printer driver of the relevant model must have been installed.

Memo:

• Refer to "APPENDIX 1 SERIAL NUMBERING SYSTEM" to know how to read the serial

number of the machine.