User Manual
Table Of Contents
- USER’S GUIDE DCP-7030 DCP-7040
- Compilation and Publication Notice
- Table of Contents
- Section I: General
- General information
- Loading paper and documents
- General setup
- Section II: Copy
- Section III: Software
- Section IV: Appendixes
- Index
- brother CHN-ENG
Safety and legal
37
A
Note
IEC60825-1+A2:2001 Specification A
This machine is a Class 1 laser product as defined in IEC60825-1+A2:2001 specifications. The
label shown below is attached in countries where required.
Laser Diode A A
Wave length: 780 - 800 nm
Output: 10 mW max.
Laser Class: Class 3B
If moving your machine, use the handholds provided. First making sure to disconnect any
cables.
DO NOT use any flammable substances, spray or
organic solvent/liquids containing alcohol/ammonia
to clean the inside or outside of the machine. Doing
this may cause a fire or electrical shock. Refer to
Routine maintenance on page 60 for how to clean
the machine.
Plastic bags are used in the packaging of your machine. To avoid the danger of suffocation,
keep these bags away from babies and children.
The fuser unit is marked with a Caution label. DO NOT remove or damage the label.
This machine has a Class 3B Laser Diode which emits invisible
laser radiation in the Scanner Unit. The Scanner Unit should not
be opened under any circumstances.