User Manual
Table Of Contents
- USER’S GUIDE DCP-7030 DCP-7040
- Compilation and Publication Notice
- Table of Contents
- Section I: General
- 1 General information
- 2 Loading paper and documents
- 3 General setup
- Section II: Copy
- Section III: Software
- Section IV: Appendixes
- A Safety and legal
- B Troubleshooting and routine maintenance
- C Menu and features
- D Specifications
- E Glossary
- Index
- brother ARL/ASA/NZ
Making copies
27
4
i After all the pages have been scanned,
press b in g to finish.
(DCP-7040 only) If you are copying
from the ADF:
4
Insert your document face up in the direction
shown below:
2 in 1 (P)
2 in 1 (L)
4 in 1 (P)
4 in 1 (L)
If you are copying from the scanner
glass:
4
Insert your document face down in the
direction shown below:
2 in 1 (P)
2 in 1 (L)
4 in 1 (P)
4 in 1 (L)
Out of memory
message
4
If the memory becomes full while you are
making copies, the LCD message will guide
you through the next step.
(DCP-7030 only) If you get an
Out of Memory message, press Stop/Exit
to cancel the operation.
(DCP-7040 only) If you get an
Out of Memory message while scanning a
subsequent page, you will have the option to
press Start to copy the pages scanned so far,
or to press Stop/Exit to cancel the operation.