User`s guide

Chapter 4
32
Using a scanned paper document as
your watermark
4
a Enter the number of copies you want.
b Press a or b to choose
Watermark Copy .
Press OK.
c Press d or c to choose On.
d Press a or b to choose
Current Setting .
Press OK.
e Press a or b to choose Scan. Press OK
and set the page that you want to use as
a watermark on the scanner glass.
f Press Mono Start or Colour Start.
g Take out the watermark document you
scanned and load the document you
want to copy.
h Press d or c to change the
Transparency of the watermark.
Press OK.
i If you do not want to change any
additional settings, press Mono Start or
Colour Start.
Note
You cannot enlarge or reduce the
scanned watermark.
Setting your changes as a
new default 4
You can save the copy settings for Quality,
Enlarge/Reduce, Brightness,
Contrast and Page Layout that you use
most often by setting them as the default
settings. These settings will stay until you
change them again.
a Press a or b to choose your new setting.
Press OK.
Repeat this step for each setting you
want to change.
b After changing the last setting, press a
or b to choose Set New Default.
Press OK.
c Press + to choose Yes.
d Press Stop/Exit.
Restoring all settings to the
factory settings 4
You can restore all the settings you have
changed back to the factory settings. These
settings will stay until you change them again.
a Press a or b to choose
Factory Reset .
Press OK.
b Press + to choose Yes.
c Press Stop/Exit.