User Manual
Table Of Contents
- SOFTWARE USER'S GUIDE
- Table of Contents
- Section I Windows®
- 1 Printing
- 2 Scanning
- 3 ControlCenter3
- 4 Network Scanning (For models with built-in network support)
- 5 Remote Setup (Not available for DCP models and MFC-240C)
- 6 Brother PC-FAX Software (MFC models only)
- PC-FAX sending
- Speed Dial setup
- Brother Address Book
- Setting up a member in the Address Book
- Setting up a group for broadcasting
- Editing member information
- Deleting a member or group
- Exporting the Address Book
- Importing to the Address Book
- Sending a file as a PC-FAX using the Facsimile style user interface
- Sending a file as a PC-FAX using the Simple style user interface
- PC-FAX receiving (Not available for MFC-240C and MFC-3360C)
- 7 PhotoCapture Center™ (Not available for MFC-3360C)
- Section II Apple® Macintosh®
- 8 Printing and Faxing
- 9 Scanning
- 10 ControlCenter2
- 11 Network Scanning (For models with built-in network support)
- 12 Remote Setup & PhotoCapture Center™
- Index
- Brother ENG
69
4
4
To use the machine as a network scanner, the machine must be configured with a TCP/IP address. You can
set or change the address settings from the control panel (See Control Panel Setup in the Network User’s
Guide) or by using the BRAdmin Professional software. If you installed the machine following the instructions
for a network user in the Quick Setup Guide then the machine should already be configured for your network.
Note
• For network scanning, a maximum of 25 clients can be connected to one machine on a network. For
example, if 30 clients try to connect at a time, 5 of those clients will not be shown on the LCD.
• If your PC is protected by a firewall, and is unable to scan you may need to configure the firewall settings
to allow communication through port number 137 and 54925. Visit the Brother Solutions Center
(http://solutions.brother.com
) for more information.
Before using Network Scanning 4
Configuring Network Scanning 4
If you are using a different machine to the one that was originally registered to your PC during the installation
of MFL-Pro Suite software (see the Quick Setup Guide), follow the steps below.
a For Windows
®
XP, click the Start button, Control Panel, Printers and Other Hardware, then
Scanners and Cameras (or Control Panel, Scanners and Cameras).
For Windows
®
98/Me/2000, click the Start button, Control Panel, then Scanners and Cameras.
b Right-click the Scanner Device icon and choose Properties.
The Network Scanner Properties dialog box appears.
Network Scanning
(For models with built-in network support)
4