User Manual
Table Of Contents
- SOFTWARE USER'S GUIDE
- Table of Contents
- Section I Windows®
- 1 Printing
- 2 Scanning
- 3 ControlCenter3
- 4 Network Scanning (For models with built-in network support)
- 5 Remote Setup (Not available for DCP models and MFC-240C)
- 6 Brother PC-FAX Software (MFC models only)
- PC-FAX sending
- Speed Dial setup
- Brother Address Book
- Setting up a member in the Address Book
- Setting up a group for broadcasting
- Editing member information
- Deleting a member or group
- Exporting the Address Book
- Importing to the Address Book
- Sending a file as a PC-FAX using the Facsimile style user interface
- Sending a file as a PC-FAX using the Simple style user interface
- PC-FAX receiving (Not available for MFC-240C and MFC-3360C)
- 7 PhotoCapture Center™ (Not available for MFC-3360C)
- Section II Apple® Macintosh®
- 8 Printing and Faxing
- 9 Scanning
- 10 ControlCenter2
- 11 Network Scanning (For models with built-in network support)
- 12 Remote Setup & PhotoCapture Center™
- Index
- Brother ENG
Network Scanning (For models with built-in network support)
137
11
Using the Scan key 11
Note
If you use the Scan key with a USB connection, see Using the Scan key (For USB cable users) on page
113.
Scan to E-mail 11
When you choose Scan to E-mail, your document will be scanned and sent directly to the Macintosh
®
you
designated on your network. ControlCenter2 will activate the default E-mail application on the designated
Macintosh
®
for addressing to the recipient. You can scan a black and white or colour document and it will be
sent with the E-mail from the Macintosh
®
as an attachment.
You can change the (Scan) configuration. (See E-mail on page 125.)
a Load your document.
b Press the (Scan) key.
c Press a or b to choose Scan to E-mail.
Press OK.
d Press a or b to choose the destination Macintosh
®
you want to use for E-mailing your document.
Press OK.
If the LCD prompts you to enter a Pin number, enter the 4-digit Pin number for the destination
Macintosh
®
on the control panel.
Press OK.
e Press Mono Start or Colour Start.
The machine starts the scanning process.