Use and Care Manual

KNOWING YOUR SEWING MACHINE
11
1
CAUTION
• Only use the bobbin that comes with this
machine or bobbins of the same type (part
code: SA156, SFB: XA5539-151). Using other
bobbins may cause damage to the machine.
SA156 is Class 15 type bobbin.
This model
Actual size
11.5 mm
(7/16 inch)
Other models
1
Press down on the spool pin lever to swing
up the spool pin. Then remove the spool cap.
1
Spool pin
2
Spool cap
CAUTION
• Do not grab the bar to raise the spool pin,
otherwise, the spool pin may bend or break.
• Be sure to raise the spool pin when winding
the bobbin. The thread may become tangled if
the bobbin winder is used without raising the
spool pin.
2
Fully insert the spool of thread for the
bobbin, and then slide the spool cap onto the
spool pin.
•The thread should be unwound from the
bottom to the front.
CAUTION
• If the spool or the spool cap is not positioned
correctly, the thread may become tangled
around the spool pin or the machine may be
damaged.
• Three spool cap sizes are available. Choose a
spool cap that best fits the size of spool being
used. If the spool cap is too small for the spool,
the thread may catch on the slit in the spool or
the machine may be damaged.
Mem
o
•When sewing with fine, cross-wound
thread, use the small spool cap, and leave a
small space between the cap and the spool.
1
3
2
1
Spool cap
(small)
2
Spool (cross-
wound thread)
3
Space
3
Pass the thread as illustrated bellow.
1
Thread guide
2
Thread guide cover