Specification

24
UTILITY STITCHES
Example: For a button with a diameter
of 15 mm (9/16 inch) and a thickness of
10 mm (3/8 inch), the button guide
plate should be set to 25 mm (1 inch)
on the scale.
2
1
1 10 mm (3/8 inch)
2 15 mm (9/16 inch)
The size of the buttonhole is set.
c
Attach buttonhole foot “A”.
Before attaching the buttonhole foot “A”,
pass the upper thread underneath the
presser foot through the hole.
d
Select a stitch.
* Stitches may differ depending on the
model. Check stitch selections on the
machine’s body, and then select the
stitch number.
e
Position the fabric with the front end of
the buttonhole mark aligned with the red
marks on the sides of the buttonhole foot,
and then lower the presser foot lever.
A
a
b
c
1 Mark on fabric (front)
2 Red marks on buttonhole foot
3 Upper thread
Note
• When lowering the presser foot, do not
push in the front of the presser foot,
otherwise the bar tack will not be sewn
with the correct size.
f
Pull down the buttonhole lever as far as
possible.
1
1 Buttonhole lever
The buttonhole lever is positioned behind
the bracket on the buttonhole foot.
2
1
1 Buttonhole lever
2 Bracket
g
Gently hold the end of the upper thread
in your left hand, and then start sewing.
 Once sewing is completed, the
machine automatically sews
reinforcement stitches, then stops.
h
Raise the needle and presser foot, then
remove the fabric, and then cut the
threads.
i
Raise the buttonhole lever to its original
position.
j
Insert a pin along the inside of one bar
tack at the end of the buttonhole
stitching to prevent the stitching from
being cut.
1
1 Pin