Instruction manual

-36- Chapter 2 Creating sewing data
151-390
4. Modifying an outline
The shape of an outline can be changed by moving or deleting the points that make up the
outline, or by adding new points to the outline. Such changes are made using the [MODIFY]
button on the button menu.
While you create an outline, you can delete the previous point until you press the [SAVE]
button, by clicking the right mouse button.
Click on the [MODIFY] button on the button menu to display the point
modification selection menu. Select the desired item on the modification
selection menu. Click the right mouse button to cancel the operation and to
return to the previous status.
If the stitch length exceeds the maximum pitch after stitch data modification, the latter will be
converted to feed data. And well, if the feed length does not reach the maximum pitch after
feed data modification, the latter will be converted to stitch data.
4-1 Adding a new point
1. Click on the [MODIFY] button on the button menu, and the ADD check box on the
modification selection menu.
The component points will appear.
2. If you add a new point to data, click on a segment of the data.
A new point will be added to the data.
3. Decide the position of the point to be added, and click the left mouse button.
Click the right mouse button to cancel the operation.
A new point cannot be added to a circle or an ellipse.
4. Click the right mouse button to finish the adding operation.