user manual
Table Of Contents
- USER’S GUIDE
- Brother numbers
- Ordering accessories and supplies
- Safety precautions
- Choosing a location
- Quick Reference Guide
- Table of Contents
- 1 Introduction
- 2 Paper
- 3 On-Screen Programming
- 4 Initial Setup
- Getting started
- Setting the Date and Time
- Turning on Automatic Daylight Savings Time
- Setting the Station ID
- Setting the Beeper Volume
- Setting the Speaker Volume
- Choosing the Handset Volume (For Volume Amplify)
- Setting Volume Amplify
- Setting the Ring Volume
- Setting Tone and Pulse dialing mode (Canada Only)
- Setting up your area code (USA only)
- Getting started
- 5 Setup Receive
- 6 Setup Send
- 7 Quick-Dial numbers and dialing options
- 8 Remote Fax Options
- 9 Printing reports
- 10 Making copies
- 11 Important information
- 12 Troubleshooting and routine maintenance
- Glossary
- Specifications
- Index
- Remote Retrieval Access Card
Initial Setup
4 - 6
Setting the Ring Volume
You can turn the ring off or you can select a ring volume level when
your machine is idle (not being used).
Press or to adjust the volume level. Every time you
press these keys, the fax machine will ring so you can hear the
active setting as the LCD shows it. The volume changes with each
key press. The new setting will stay until you change it again.
Setting Tone and Pulse dialing mode (Canada Only)
1
Press Menu/Set, 1, 6.
2
Press
▲
or ▼ to select PULSE
(or TONE).
Press Menu/Set.
3
Press Stop/Exit.
Setting up your area code (USA only)
If you must dial the area code to call within your area code, do not
enter this setting.
1
Press Menu/Set, 0, 4.
2
Use the dial pad to enter your
area code, and then press
Menu/Set.
3
Press Stop/Exit.
▲
▲
6.TONE/PULSE
4.CALLER ID
AREA CODE:000
AREA CODE:908