User`s guide
Table Of Contents
- Definitions of warnings, cautions, and notes
- To use the printer safely
- Brother Numbers (USA and Canada)
- Frequently asked questions (FAQs)
- Important information: Regulations
- Federal Communications Commission (FCC) Declaration of Conformity (For USA)
- Industry Canada Compliance Statement (For Canada)
- Radio interference (220 to 240 volt model only)
- International ENERGY STAR® Compliance Statement
- Laser Safety (100 to 120 volt model only)
- FDA Regulations (100 to 120 volt model only)
- IEC 60825 specification (220 to 240 volt model only)
- IMPORTANT - For Your Safety
- Trademarks
- Table of Contents
- About this printer
- Driver and software
- Control panel
- Options
- Routine maintenance
- Troubleshooting
- Appendix
- INDEX
CONTROL PANEL 3 - 11
Network factory default setting (For HL-5070N)
If you wish to reset the print server back to its default factory settings (resetting all information such as
the password and IP address information), please follow these steps:
1
Turn off the printer.
2
Make sure that the front cover is closed and the power cord is plugged in.
3
Hold down the Go button as you turn on the power switch. All the LEDs will light up. Keep the button
pressed down until the Toner LED comes on. When the Toner LED comes on, release the Go
button.
4
Hold down the Go button and keep it pressed down until the yellow Status LED comes on. When
the Status LED comes on, release the Go button.
5
When all the LEDs light up again, the printer will start warming up. The print server has been reset
to its default factory settings.
■ If you wish to reset the printer and automatically disable the APIPA protocol, follow steps 1 to 4
above, however, hold down the Go button until the Status LED is green, not yellow.
■ For more information on APIPA, see the Network User’s Guide or visit
http://solutions.brother.com