User`s guide
Table Of Contents
- Definitions of warnings, cautions, and notes
- To use the printer safely
- Brother Numbers (USA and Canada)
- Frequently asked questions (FAQs)
- Important information: Regulations
- Federal Communications Commission (FCC) Declaration of Conformity (For USA)
- Industry Canada Compliance Statement (For Canada)
- Radio interference (220 to 240 volt model only)
- International ENERGY STAR® Compliance Statement
- Laser Safety (100 to 120 volt model only)
- FDA Regulations (100 to 120 volt model only)
- IEC 60825 specification (220 to 240 volt model only)
- IMPORTANT - For Your Safety
- Trademarks
- Table of Contents
- About this printer
- Driver and software
- Control panel
- Options
- Routine maintenance
- Troubleshooting
- Appendix
- INDEX
3 - 6 CONTROL PANEL
Table 1: LED indications after pressing Go and Job Cancel
Make a note of the indication and report the error status to your dealer or a Brother authorized service
representative by referring to the above table.
LEDs Fixing unit
failure
Laser unit
failure
Main motor
failure
Main PCB
failure
Engine PCB
failure
DIMM failure
Toner
Drum
Paper
Status
Make sure that the front cover is fully closed before you report a service call.