User`s guide
Table Of Contents
- Definitions of warnings, cautions, and notes
- To use the printer safely
- Brother Numbers (USA and Canada)
- Frequently asked questions (FAQs)
- Important information: Regulations
- Federal Communications Commission (FCC) Declaration of Conformity (For USA)
- Industry Canada Compliance Statement (For Canada)
- Radio interference (220 to 240 volt model only)
- International ENERGY STAR® Compliance Statement
- Laser Safety (100 to 120 volt model only)
- FDA Regulations (100 to 120 volt model only)
- IEC 60825 specification (220 to 240 volt model only)
- IMPORTANT - For Your Safety
- Trademarks
- Table of Contents
- About this printer
- Driver and software
- Control panel
- Options
- Routine maintenance
- Troubleshooting
- Appendix
- INDEX
CONTROL PANEL 3 - 1
3
This section refers to the four Light Emitting Diodes (LEDs) (Toner, Drum, Paper, Status) and the two
control panel buttons (Job Cancel, Go) on the control panel.
Figure 3-1
The LED indications shown in the table below are used in the illustrations in this chapter.
Control panel
LED is off
or or
LED is on
or
or
LED is blinking
When the power switch is off or the printer is in Sleep mode, all the LEDs are off.