User`s guide
Table Of Contents
- Definitions of warnings, cautions, and notes
- To use the printer safely
- Brother Numbers (USA and Canada)
- Frequently asked questions (FAQs)
- Important information: Regulations
- Federal Communications Commission (FCC) Declaration of Conformity (For USA)
- Industry Canada Compliance Statement (For Canada)
- Radio interference (220 to 240 volt model only)
- International ENERGY STAR® Compliance Statement
- Laser Safety (100 to 120 volt model only)
- FDA Regulations (100 to 120 volt model only)
- IEC 60825 specification (220 to 240 volt model only)
- IMPORTANT - For Your Safety
- Trademarks
- Table of Contents
- About this printer
- Driver and software
- Control panel
- Options
- Routine maintenance
- Troubleshooting
- Appendix
- INDEX
2 - 5 DRIVER AND SOFTWARE
Device Options
You can set the following Printer Function modes in this tab:
(You can jump to the page for each Printer Function by clicking the function name in the list below.)
■ Job Spooling
■ Quick Print Setup
■ Sleep Time
■ Status Monitor
■ Macro (For HL-5040, HL-5050 and HL-5070N)
■ Page Protection
■ Print Date & Time
■ Density adjustment
■ HRC (High Resolution Control)*
■ TrueType Mode (For HL-5040, HL-5050 and HL-5070N)*
The Printer Function list may differ depending on the model.
*
If you are using Windows
®
95, 98 or Me, you can change settings of HRC and TrueType Mode in
Print Setting in the Print Quality option of the Advanced tab.