User`s guide
Table Of Contents
- Definitions of warnings, cautions, and notes
- To use the printer safely
- Brother Numbers (USA and Canada)
- Frequently asked questions (FAQs)
- Important information: Regulations
- Federal Communications Commission (FCC) Declaration of Conformity (For USA)
- Industry Canada Compliance Statement (For Canada)
- Radio interference (220 to 240 volt model only)
- International ENERGY STAR® Compliance Statement
- Laser Safety (100 to 120 volt model only)
- FDA Regulations (100 to 120 volt model only)
- IEC 60825 specification (220 to 240 volt model only)
- IMPORTANT - For Your Safety
- Trademarks
- Table of Contents
- About this printer
- Driver and software
- Control panel
- Options
- Routine maintenance
- Troubleshooting
- Appendix
- INDEX
ABOUT THIS PRINTER 1 - 17
Printing on thicker paper and card stock
When the back output tray is pulled down, the printer has a straight paper path from the manual feed tray
or the MP tray through to the back of the printer. Use this paper feed and output method when you want
to print on thicker paper or card stock.
When you select the paper you want to use, please see What kind of paper can I use? in this chapter.
Printing on thicker paper and card stock from the manual feed tray
(For HL-5030 and HL-5040)
1
Select the Paper Size, Media Type, Paper Source, and other settings in the printer driver.
Media Type: Thick paper or Thicker paper
Paper Source: Manual
PCL driver
2
Open the back output tray.
Figure 1-17