User`s guide
Table Of Contents
- Definitions of warnings, cautions, and notes
- To use the printer safely
- Brother Numbers (USA and Canada)
- Frequently asked questions (FAQs)
- Important information: Regulations
- Federal Communications Commission (FCC) Declaration of Conformity (For USA)
- Industry Canada Compliance Statement (For Canada)
- Radio interference (220 to 240 volt model only)
- International ENERGY STAR® Compliance Statement
- Laser Safety (100 to 120 volt model only)
- FDA Regulations (100 to 120 volt model only)
- IEC 60825 specification (220 to 240 volt model only)
- IMPORTANT - For Your Safety
- Trademarks
- Table of Contents
- About this printer
- Driver and software
- Control panel
- Options
- Routine maintenance
- Troubleshooting
- Appendix
- INDEX
ABOUT THIS PRINTER 1 - 13
3
Open the manual feed tray. Slide the paper guides to fit the paper size.
Figure 1-11
4
Using both hands put paper in the manual feed tray until the front edge of the paper touches the
paper feed roller. Hold the paper in this position until the printer automatically feeds the paper in for
a short distance, and then let go of the paper.
Figure 1-12
5
After the printed page comes out of the printer, put in the next sheet of paper as in Step 4 above.
Repeat for each page that you want to print.
■ Make sure that the paper is straight and in the proper position on the manual feed tray. If it is
not, the paper may not be fed properly, resulting in a skewed printout or a paper jam.
■ Do not put more than one piece of paper in the manual feed tray at any one time, or it may cause
a jam.
■ If you put any Media (paper, transparency and so on) in the manual feed tray before the printer
is in the Ready state, the media may be ejected without being printed on.