User`s guide
Table Of Contents
- Definitions of warnings, cautions, and notes
- To use the printer safely
- Brother Numbers (USA and Canada)
- Frequently asked questions (FAQs)
- Important information: Regulations
- Federal Communications Commission (FCC) Declaration of Conformity (For USA)
- Industry Canada Compliance Statement (For Canada)
- Radio interference (220 to 240 volt model only)
- International ENERGY STAR® Compliance Statement
- Laser Safety (100 to 120 volt model only)
- FDA Regulations (100 to 120 volt model only)
- IEC 60825 specification (220 to 240 volt model only)
- IMPORTANT - For Your Safety
- Trademarks
- Table of Contents
- About this printer
- Driver and software
- Control panel
- Options
- Routine maintenance
- Troubleshooting
- Appendix
- INDEX
TROUBLESHOOTING 6 - 15
Envelope creases
■ Open the back output tray and push down the blue tabs at the left and
right hand sides (as shown in the figure below). When you have
finished printing your envelopes, close the back output tray to reset the
two blue tabs back to their original position. See page 1-31.
Examples of poor print
quality
Recommendation
ABCDEFG
EFGHIJKLMN